Description

Features:

·Loud 85 decible alarm.

·Permanent carbon monoxide sensor.

·Powered by one 9V battery.

·The alarm sound pattern is pulsed four short alarm beeps for CO alarm and continuous beeps for smoke alarm. The sound pattern is smoke pattern as CO and smoke occur concurrently. The red LED will flash even as in alarm mode.

·One “chirp” each 30 seconds is a sign that the battery is low(need replacement) or the unit is malfunctioning.

·Test button to check the units electronics and verifies proper unit operation.

·Green and red LED lights that indicate normal operation and alarm status.

·The unit will sound “chirp” and red LED flashes once as power up.

Green LED: The green LED flashes each 30 seconds to suggest the unit is operating properly.

Red LED: When a dngerous level of carbon monoxide is detected and a potential fire is detected, the red LED will flashes and the alarm pattern will sound.

The CARBON MONOXIDE (CO) & SMOKE combination alarm monitors the air for the presence of CO or a potential fire. The alarm will sound and be accompanied by the flashing red LED light when there are high levels of CO present or there’s a potential fire present.

CAUTION: This alarm will only indicate the presence of carbon monoxide gas on the sensor. Carbon monoxide gas would possibly present at other area.


Specifications:

Power Supply: one 9V carbon zinc battery 6F22.

Sensitivity Setting:

CO: Alarm Density:

30ppm,alarms not turn on within 120minutes

50ppm, alarms within 60~90 minutes

100ppm, alarms within 10~40 minutes

300ppm, alarms within 3 minutes

SMOKE: 1%~5%/FT OBS

Standby Current: <25uA
Alarm Current: <45mA
Operation Ambient Condition: 5~400C, 20~90%R.H.
·Loud 85 decible alarm.
·Permanent carbon monoxide sensor.
·Powered by one 9V battery.
·The alarm sound pattern is pulsed four short alarm beeps for CO alarm and continuous beeps for smoke alarm. The sound pattern is smoke pattern as CO and smoke occur concurrently. The red LED will flash even as in alarm mode.
·Test button to check the units electronics and verifies proper unit operation.